Clutch & Transmission

Displaying 1 to 10 (of 15 products)

1 2 [Next >>]

Product Image	Item Name	Price+
	MOLD-A-GAUGE Non-stick, non-shrink, heat cured material, used to measure the end play of the input, intermediate, and output shafts on the /2 /5 /6 /7 R26 R27 and...	$7.00 Add:
	CLUTCH INSTALLATION/REMOVAL BOLTS Three fine-thread bolts, nuts and hardened washers used to compress the diaphragm spring so you can remove and install the clutch components. They're...	$8.00 Add:
	STEEL PARALLELS Set of two 1/2 inch steel parallels, 6 inches long. Set these on your transmission cover to measure bearing recess depth and on your transmission...	$13.00 Add:
	/2 TRANSMISSION COVER PULLER Well...it pulls the transmission cover (after you've pulled the output flange). Saves you and your transmission cover from the endless "tapping"...	$14.00 Add:
	CAMSHAFT/TRANSMISSION BEARING PULLER To pull the cam bearing (6203) out of the blind hole in the back of the pre 1970 engine block, as well as the 3203 and 6203 bearings supporting the...	$32.00 Add:
	TRANSMISSION OUTPUT SHAFT HOLDER - SINGLES & TWINS Replaces Matra 504 - used to support the transmission output shaft while adjusting the shifter forks.	$32.00 Add:
	CLUTCH INSTALLING TOOLS - 1955-1969 TWINS For assembly/disassembly and aligning of the clutch. Includes the three bolts needed to remove/install the clutch. Replaces Matra 529 534 BMW 21 2...	$36.00 Add:
	CLUTCH INSTALLING TOOLS - SINGLES & 1951-1954 TWINS For assembly/disassembly and aligning of the clutch. Includes the three bolts needed to remove/install the clutch. This version of the tool comes...	$36.00 Add:
	TRANSMISSION OUTPUT NUT SOCKET - SINGLE CYLINDER BIKES & PRE /2 For R12 R24 R25 R26 R27 R51/2 R51/3 R67 R68 - same as the small /2 output nut socket but without hold down	$45.00 Add:
	TRANSMISSION OUTPUT NUT SOCKET - 1967-1969 (LARGE) For dealing with that funny nut buried in the transmission output flange. Includes a hold down which keeps the socket from sliding off the nut. This...	$54.00 Add: