Engine

Displaying 1 to 10 (of 18 products)

1 2 [Next >>]

Product Image	Item Name	Price+
	/2 (AND EARLIER) POINTS ADJUSTING TOOL The original "repairhead" points adjusting tool from Paul Tavenier. Replaces the advance unit while you adjust the points - makes things much easier...	... more info Call for price
	GENERATOR/ALTERNATOR/MAGNETO ROTOR PULLER A modified 120mm-long class 10.9 bolt used to remove the generator, magneto or alternator rotor. For all air cooled twins 1951-1995 and R24 R25 R26 &...	$8.00 Add:
	PUSHROD TUBE DRIFT I 1951-95 AIRHEADS DRIFT 1: Replaces Matra 530a, used to remove/install the chromed tubes on the top of the 1951-69 cylinders and I believe also all post 1969 airheads....	$11.00 Add:
	DIAL INDICATOR HOLDER TO MEASURE FLYWHEEL RUNOUT and END PLAY To minimize engine vibration and prevent premature failure of the transmission input shaft bearing, the runout of the flywheel should be checked, and...	$14.00 Add:
	PUSHROD TUBE DRIFT II 1951-95 AIRHEADS DRIFT 2: Replaces BMW 211 (11.1.600) used to push the chromed ring on the pushrod tube against the rubber grommet in the engine block to prevent oil...	$14.00 Add:
	41mm FLYWHEEL BOLT SOCKET Heavy duty 1/2" drive impact socket with the end faced flat to ensure it doesn't slip off the shallow head of the flywheel bolt while you're torquing...	$22.00 Add:
	LIFTER (TAPPET) GUIDE REMOVER R27 For the R27 with smooth lifter (tappet) guides that screw into the block without the hex flats for a wrench. Sometimes heat and a strap wrench will...	$29.00 Add:
	DIAL INDICATOR Used with the Crankshaft truing stand, The Flywheel runout fixture, and the Front end alignment tools. .0005” resolution, 1-inch range	$32.00 Add:
	CAMSHAFT/TRANSMISSION BEARING PULLER To pull the cam bearing (6203) out of the blind hole in the back of the pre 1970 engine block, as well as the 3203 and 6203 bearings supporting the...	$35.00 Add:
	REAR MAIN BEARING PULLER (PART OF THE MANY-IN-ONE TOOL) If you purchased a Many-In-One tool before 16 Feb 1996, and want to pull the rear main bearing without crushing the slinger, that is what this tool...	$36.00 Add: